1.5 Ce Comments; Emc Directive; Emission Testing; Low Voltage Directive (Safety) - Fluke 4181 User Manual

If a main supply power fluctuation occurs, immediately turn off the instrument. Wait
until the power has stabilized before re-energizing the instrument.
Use the target cover at temperatures below ambient (25°C). If ice or liquid water
forms on the target, IR thermometers will not indicate the correct temperature.

1.5 CE Comments

1.5.1

EMC Directive

Hart's equipment has been tested to meet the European Electromagnetic Compatibil-
ity Directive (EMC Directive, 89/336/EEC). The Declaration of Conformity for your
instrument lists the specific standards to which the instrument was tested.
The instrument was designed specifically as a test and measuring device. Compliance
to the EMC directive is through IEC 61326-1 Electrical equipment for measurement,
control and laboratory use.
As noted in the IEC 61326-1, the instrument can have varying configurations. The
instrument was tested in a typical configuration with shielded RS-232 cables.
1.5.2

Emission Testing

The instrument fulfills the limit requirements for Class A equipment. The instrument
was not designed to be used in domestic establishments.
1.5.3

Low Voltage Directive (Safety)

In order to comply with the European Low Voltage Directive (2006/95/EC), Hart's
equipment has been designed to meet the EN 61010-1 and EN 61010-2-010 standards.

1.6 Authorized Service Centers

Please contact one of the following Authorized Service Centers to coordinate service
on your Hart product:
Fluke Corporation
Hart Scientific Division
Before You Start
Authorized Service Centers
7