Table of Contents
Advertisement
15
Bottom transporter zero position
.06.03
Rule
At stitch length regulation "0"
1. The marking on the toothed segment 1 should be in the centre of the shaft of the gear
wheel 3,
2. The cranks 4 and 6 should be aligned and the bottom transporter should not move
when turning the handwheel.
Fig. 15 - 04
O Switch the machine on.
O Set the stitch length to "0" using the control panel and turn the handwheel until the feed
0.0
regulator motor responds.
O Make sure that parameter 834 is set to "0", see chapter 15.11 Parameter settings.
O Adjust the toothed segment 1 ( screws 2 ) without the gear wheel 3 according to rule 1.
O Turn the crank 4 ( screws 5 ) according to rule 2.
O Switch the machine off.
6
4
5
2
3
Adjustment
2
1
9
Advertisement
Table of Contents
