Peavey PR 15 D Operating Manual page 5

Applications
®
The Peavey PR
system, karaoke or musical playback. With the optional monitor stand kit, the Peavey PR 15D makes an
excellent stage monitor.
A typical signal source for the line-level inputs of the Peavey PR 15D would be a sound reinforcement
mixing console (mixer) or the output from a CD player, iPod player or tape deck. A dynamic microphone
can be connected and used as well.
R E A R P A N E L
FuSE
The unit is AC power line fuse protected from overloads and fault conditions with a fast-blow 3.15 Amp
fuse. This fuse is located within the cap of the enclosure. If the fuse fails, THE FUSE MUST BE REPLACED
WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT
VOIDING THE WARRANTY. If the unit blows a fuse, it should be taken to a qualified service center for repair.
IEC POWER CORD CONNECTION
1
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit.
It is very important that you ensure the PR 15D has the proper AC line voltage supplied. You can find the proper voltage
for your PR 15D printed next to the IEC line (power) cord on the rear panel of the unit. Please read this guide carefully
to ensure your personal safety as well as the safety of your equipment.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have
a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
ON-OFF SWITCH
2
This rocker switch supplies AC power to the PR 15D when switched to the ON position.
15D has a variety of applications such as sound reinforcement, public address, side fill
1
5
2