Getting Started; Installing Sim Card And Battery; Charging; Power On / Off - Videocon V200 User Manual

1

Getting Started

1.1

Installing SIM Card and Battery

When you subscribe to a cellular service, you will receive a Subscriber Identity Module (SIM) with
subscription details, such as your Personal Identification Number (PIN) and optional services.
To install SIM card and Battery:
1. Switch OFF the Phone
2. Remove the battery cover
3. Insert the SIM card
4. Insert the Battery
5. Replace the Battery cover and Switch ON the phone
Note:
1.2

Charging

Insert the Plug of your charger to the charging port at the base of your phone.
When you begin to charge the battery, the stripe of Signal Strength on the right corner of the
screen starts to roll. When battery gets fully charged, the stripe becomes stable and stops rolling.
Note:
1.3

Power ON / OFF

Press End Key for max of 5-10 seconds to Power ON. On getting ON the backlight brighten and
animation gets displayed.
If Phone asks for a PIN code, enter the PIN Code and select "OK".
The Lock code for the phone in factory setting is 0000.
Press End Key for max of 5-10 seconds to Power OFF.
1.4

Using Headset

Connect the headset to the mobile headset socket. To answer a call, press headset key and
again to end a call, press headset key.
Please do not touch the metal area to avoid losing and breaking the information
in SIM card. Avoid SIM from putting it nearby electricity and magnetism.
1. Please charge the battery, after it is completely consumed and then charge
full to make your battery in best state.
2. Using the phone while charging may extend the charging time.
3. If battery gets fully discharged, the phone will automatically get switched off.