Table of Contents
Advertisement
Interior
Designs
Shelves
Fresh
Food Compartment
and Door
The fresh food compartment also may be equipped with
adjustable, Spi|l-Cateher
TM
shelves. These shelves have a
Elevator
TM
Shelf
spill retainer edge for easy clean up.
The fresh food compartment is equipped with Elevator
TM
shelves. These shelves have a spill retainer edge for easy
In some models, these shelves bare the slide out feature.
clean up. They also have the convenient slide out feature
To slide out, simply grasp the front of the shelf and pull.
that allows easy access to items stored at the rear of the shelf.
Gently push in to return the shelf to the original position.
These shelves can be adjusted up or down without having
to be unloaded of their contents. To adjust an Elevator '_'
shelf, unfold the recessed crank handle so it is at a right
angle to the shelf front. Crank to the right (clockwise) to
raise the height of the shelf, and the left Icounterclockwise)
to lower the height of the shelf.
To remove the Elevator" shelf for occasional cleaning:
• Completely unload the shelf.
• Grasp the shelf front and pull forward until it stops.
These shelves can be moved for varying food storage
• Press the stops from below (both sides) upward and
needs.
continue pulling the shelf forward, clear of the frame.
To remove a shelf:
• To reinstall, align the shelf to the frame and push it all
the way back. (There is no need to depress the stops for
• completely unload the shclf
reinstallation).
• slightly lift up the rear of the shelf
In ordinary use, the Elevator
TM
shelf with the frame assem-
• pull the shelf straight out
bly does NOT require removal. Though unlikely, and not
recommended, the correct removal procedure is as follows:
To lock a shelf into another position:
• Unload the shelf completely.
- tilt up the front edge of the shelf
• Slide the shelf forward about two inches and manually
• insert the hooks into the desired frame openings
move the two rear latches toward the shelf center.
• let the shelf settle into place
• While supporting the entire shelf and frame from
• be sure the shelf is securely locked at the rear before
underneath,
lift slightly and rotate the assembly
reloading
approximately 30° to allow the rear mechanism to clear
the vertical rear side rails,
• The entire assembly can then be moved forward and
clear of the refrigerator compartment.
• To reinstall, reverse the removal procedure. Be sure the
shelf is in a level position. When the sliding shelf is
pushed to the rear, it will reposition the rear latches to
their correct operating position.
I
Advertisement
Table of Contents
