Interior Designs - Jenn-Air JCD2389DTB Guide Installation Instructions Manual

Interior Designs 6
Shelves
Fresh Food Compartment and Door
Elevator" Shelf
The Elevator" shelf is equipped with a spill-retaining edge
and the Easy Glide slide-out feature. It can be adjusted up
or down without unloading. To slide out, grasp the front of
the shelf and pull forward. Push the shelf in to return to
original position.
To adjust the Elevator" shelf: Pull out the knob on the
crank handle. Rotate the crank clockwise to raise the shelf,
and counterclockwise to lower the height of the shelf.
To remove: To remove the Elevator
TM
shelf for occasional
cleaning, completely unload the shelf and pull the shelf for-
ward. When the shelf stops, press up on the tabs located
underneath its outside edges, then continue pulling for-
ward, clear of the frame.
To replace: Align the shelf to the frame and push it all the
way back. It is not necessary to depress the tabs for rein-
stallation.
In ordinary use, the Elevator
TM
shelf frame assembly does
NOT require removal. Though unlikely, and not recom-
mended, the correct removal procedure is as follows:
• Unload the shelf completely.
• Slide the shelf forward about two inches and manually
move the two rear latches toward the sheff center.
• While supporting the entire shelf and frame from
underneath, lift slightly and rotate the assembly
approximately 30 ° to allow the rear mechanism to clear
the vertical rear side rails.
• The entire assembly can then be moved forward and
clear of the refrigerator compartment.
• To reinstall, reverse the removal procedure. Be sure the
shelf is in a level position. When the sliding shelf is
pushed to the rear, it will reposition the rear latches to
their correct operating position.
The fresh food compartment also may be equipped with
adjustable, Spill-Catcher" shelves. These shelves have a
spill retainer edge for easy clean up.
In some models, these shelves have the slide out feature.
To slide out, simply grasp the front of the shelf and pull.
Gently push in to return the shelf to the original position.
These shelves can be moved for varying food storage
needs.
To remove a shelf:
• completely unload the shelf
• slightly lift up the rear of the shelf
• pull the shelf straight out
To lock a shelf into another position:
• tilt up the front edge of the shelf
• insert the hooks into the desired frame openings
• let the shelf settle into place
• be sure the shelf is securely locked at the rear before
reloading
RAILS
FRAME ASSEMBLY
SLIDE OUT SHELF
(Style may vary)