Table of Contents
Advertisement
Storage
and Maintenance
jCi
Cleaning Under the Refrigerator
cartridge. A new cartridge can be installed when the
Your refrigerator can be rolled out for cleaning the floor
refrigerator is put back in service.
underneath. Raise the leveling feet if engaged (see page
3). Pull the refrigerator straight out from the wall.
Note: Disconnecting power to the refrigerator will sus-
pend the 12 month countdown for the water filter change
Vacations
reminder (select models).
If you will be gone for a month or less, leave the controls
e) clean and dry the refrigerator thoroughly,
at the usual settings,
f) leave the doors open to prevent odors.
During longer absences:
a) remove all food,
Moving
b) shut off the ice maker (if installed) and the valve where
When moving, follow steps a-f under Vacations• In addi-
you tapped into the water line to supply the refrigerator,
tion, remove and carefully pack any items that are easily
c) disconnect the refrigerator from the electrical outlet,
removable. Ship the refrigerator in an upright position with
d) remove the filter cartridge (certain models) and install
the doors taped shut.
the filter bypass (see page 14-15). Dispose of the used
Replacing a Light Bulb
CAI_i'ION:
Disconnect
the power
cord before replacing
light bulb(s). Wear gloves as [
protection
against
possible broken glass.
I
Always
use a standard
40 or 60 watt
appliance
bulb when replacing
a fresh food
or freez-
er compartment
bulb.
Refrigerator
Freezer
There are two light bulbs located at the top of the refriger-
The freezer light is located on the back wall of the freezer
ator compartment, on the underside of the Twin Fresh '_
compartment.
control housing.
To replace:
To replace a lightbulb(s), remove the control cover from
• unhook the tabs on the top of the light shield by press-
the control housing:
ing in with the thumb on the center top of the light
• grasp the control cover at the two rear "finger tabs",
shield.
These are located at the upper rear of the fresh food
• pivot the shield down.
compartment, behind the light shields.
• unscrew the bulb when cool and replace it with a stan-
• pull down slightly to clear the retainer tabs and slide the
dard 40-watt appliance bulb.
cover forward until it is free.
• replace the bulb(s) with a 60-watt, standard base appli-
. replace the bulb cover by pivoting it back into place and
ance bulb(s),
snapping the tabs into the appropriate slots.
• After replacing the bulb(s), align the control cover on to
the ribs on the control housing and slide it straight back
Dispenser
Light (dispenser
models
only)
until it snaps onto the retainer tabs.
To replace:
On certain models, there is an additional light located
• Locate the lightbulb in the dispenser area to the left of
behind the top drawer. To replace:
the actuator.
• remove the top drawer and cover as explained on page 10.
• Unscrew the used bulb and remove.
• carefully reach into the bulb cover and unscrew the
• Replace the bulb, using a 120V, 7-watt bulb.
lightbulb.
• replace the bulb with a 60-watt appliance bulb.
Advertisement
Table of Contents
