Figure 6 AC receptacle on the rear of the 1424T switch
After you power the switch up, the LED indicators should respond as described in
Table
Table 1 LED behavior
LED indicator
All LEDs
Power
Console
100M
Status LED
The
Status
management session over the switch's RS-232 serial port.
1.
LED lights when a remote management station initiates a console
Chapter 3 Understanding the LEDs
Behavior
Flashes momentarily to represent a system reset.
Remains on after the switch is powered up.
Flashes while the 1424T switch loads onboard software
and performs a self-test. It remains on if there is a
connection at the RS-232 port. Otherwise, this LED
indicator is off.
Depending on the transmission speed remains on or
turns off.
Installing the Passport 1424T Series Layer 3 Switch
29