Table of Contents
Advertisement
Enclosure
The 1424T switch consists of a standard 19-inch rack-mountable, sheet metal
enclosure. Your shipping container contains a mounting kit to mount the switch in
a standard 19" electronic equipment rack.
Cooling fans and air vents are located on the sides and the back panel of the
enclosure. When mounting the switch, ensure that these cooling fans and vents are
not blocked. In addition, you should allow sufficient airflow to prevent the switch
from over-heating.
Power supply
The 1424T switch Power LED is located on the switch's front panel. It indicates
that the power supply is connected to AC power and is functioning properly.
Cooling fans
The 1424T switch contains two cooling fans, located along the right-side panel,
and one air intake vent located on the switch's rear panel. When installing or
mounting the switch in a wiring cabinet or equipment rack, ensure that these fans
and the air intake vent are not blocked.
Chapter 1 Introducing the 1424T switch
Installing the Passport 1424T Series Layer 3 Switch
19
Advertisement
Table of Contents
