Configuring Wireless Device Settings; Other Information; Connecting To Your Mobile Device Via Wifi - Hi-level 48UHL950 Operating Instructions Manual

depending on the radio wave conditions,
DECT phones or any other WiFi 11b
appliances. The standard values of the
transmission speed are the theoretical
maximum values for the wireless standards.
They are not the actual speeds of data
transmission.
• The location where the transmission is most
effective differs depending on the usage
environment.
• The Wireless feature of the TV supports
802.11 a,b,g & n type modems. It is highly
recommended that you should use the IEEE
802.11n communication protocol in order to
avoid any possible problems while watching
videos.
• You must change your modem's SSID when
there are any other modems around with the
same SSID. You can encounter connection
problems otherwise. Use a wired connection
if you experience problems with a wireless
connection.

Configuring Wireless Device Settings

Open the Network Settings menu and select
Network Type as Wireless Device to start
connection process.
The TV will scan the wireless networks
automatically. A list of available networks
will be displayed. Please select your desired
network from the list.
Note: If the modem supports N mode, you
should set N mode settings.
If the selected network is protected with a
password, please enter the correct key by
using the virtual keyboard. You can use this
keyboard via the directional buttons and the
OK button on the remote control.
Wait until the IP address is shown on the
screen.
This means that the connection is now
established. To disconnect from a wireless
network, highlight Network Type and press
Left or Right buttons to set as Disabled.
Highlight Internet Speed Test and press the
OK button to check your internet connection
speed. Highlight Advanced Settings and
press the OK button to open the advanced
setting menu. Use directional and numeric
buttons to set. Press the OK button to save
settings when complete.

Other Information

The status of the connection will be displayed
as Connected or Not Connected and
the current IP address, if a connection is
established.

Connecting to your mobile device via WiFi

• If your mobile device has WiFi feature, you
can connect it to your TV via a router, in
order to access the content in your device.
For this, your mobile device must have an
appropriate sharing software.
• Connect to your router following the steps
stated above in the Wireless Connectivity
section.
• Afterwards, engage your mobile device with
the router and then activate the sharing
software on your mobile device. Then, select
files that you want to share with your TV.
• If the connection is established correctly, you
will be able to access the shared files from
your mobile device via the Media Browser
of your TV.
• Enter the Media Browser menu and the
playback device selection OSD will be
displayed. Select your mobile device and
press the OK button to continue.
• If available, you can download a virtual
remote controller application from the
English - 93 -