Advanced Epg And Extended Programme Info Banner; Teletext Services; Digital Teletext; Software Upgrade - Hi-level 48UHL950 Operating Instructions Manual

Advanced EPG and Extended
Programme Info Banner
If your TV is connected to a network the
Advanced EPG screen will be displayed by
pressing the Epg button on the remote. In this
advanced mode of EPG application all the
informations about the events are collected
from the internet database.
You can navigate through the application
using the coloured buttons via the defined
short-cuts for each. Follow the on-screen
instructions.
Extended Info Banner
A network connection is also needed to
access extended info banner. Press the Info
button on the remote twice to open the
extended Info bar. Using left or right buttons
you can see the previous or next events of the
channel being watched. Informations such as
event type, channel name etc. can be seen on
the info banner.

Teletext Services

Press the Text button to enter. Press again
to activate mix mode, which allows you to
see the teletext page and the TV broadcast
at the same time. Press once more to exit. If
available, sections in the teletext pages will
become colour-coded and can be selected
by pressing the coloured buttons. Follow the
instructions displayed on the screen.

Digital Teletext

Press the Text button to view digital teletext
information. Operate it with the coloured
buttons, cursor buttons and the OK button.
The operation method may differ depending
on the contents of the digital teletext. Follow
the instructions displayed on the digital
teletext screen. When the Text button is
pressed again, the TV returns to television
broadcast.

Software Upgrade

Your TV is capable of finding and updating the
firmware automatically via the broadcast signal
or via Internet.
Software upgrade search via user
interface
On the main menu select System>Options
and then More. Navigate to Software
upgrade and press the OK button. In
Upgrade options menu select Scan for
upgrade and press OK button to check for
a new software upgrade.
If a new upgrade is found, it starts
to download the upgrade. After the
download is completed confirm the
question asking about rebooting the TV
by pressing the OK to continue with the
reboot operation.
3 AM search and upgrade mode
Your TV will search for new upgrades at 3:00
o'clock if Automatic scanning option in the
Upgrade options menu is set to Enabled
and if the TV is connected to an aerial signal
or to Internet. If a new software is found and
downloaded successfully, it will be installed at
the next power on.
Note: Do not unplug the power cord while
led is blinking during the reboot process. If
the TV fails to come on after the upgrade,
unplug, wait for two minutes then plug it
back in.
Troubleshooting & Tips
Tv will not turn on
Make sure the power cord is plugged in
securely to wall outlet. Check if batteries are
exhausted. Press the Power button on the TV.
English - 81 -