"TV switched to stand-by mode
displayed.
automatically because no operation was
made for a long
time." Press OK to continue.
TV Control Buttons
& Operation
+
+
1. Standby/On button
2. Source button
3. Programme +/- buttons
4. Volume +/- buttons
Press the Volume +/- buttons simultaneously
to view main menu and use Programme +/-
buttons to navigate and Volume +/- buttons
to change value.
Note: The position of the control buttons
may differ depending on the model.
Operation with the Remote Control
Press the Menu button on your remote
control to display main menu screen. Use the
directional buttons to select a menu tab and
press OK to enter. Use the directional buttons
again to select or set an item. Press Return/
Back or Menu button to quit a menu screen.
Input Selection
Once you have connected external systems
to your TV, you can switch to different input
sources. Press the Source button on your
remote control consecutively to select the
different sources.
Changing Channels and Volume
You can change the channel and adjust
the volume by using the Volume +/- and
Programme +/- buttons on the remote.
Inserting the Batteries into the
Remote
Remove the back cover to reveal the battery
compartment. Insert two size AAA batte-
ries. Make sure the (+) and (-) signs match
(observe correct polarity). Do not mix old
and new batteries. Replace only with same
or equivalent type. Place the cover back on.
Connect Power
IMPORTANT: The TV set is designed to
operate on 220-240V AC, 50 Hz socket.
After unpacking, allow the TV set to reach
the ambient room temperature before you
connect the set to the mains. Plug the power
cable to the mains socket outlet.
Antenna Connection
Connect the aerial or cable TV plug to the
AERIAL INPUT (ANT-TV) socket or satellite
plug to the SATELLITE INPUT (ANT SAT)
socket located on the rear bottom side of
the TV.
Rear bottom side of the TV
satellite
Notification
TRADEMARK ACKNOWLEDGMENT
The terms HDMI and High-Definition
English - 65 -
aerial
or
cable