Functional Description - Makita 2712 Instruction Manual

2
3
1. Sub table
2. Stay (short)
3. Stay (long)
014574
13. Install the hook to the leg.
014575
14. Locate the table saw in a well lit and level area
where you can maintain good footing and balance.
It should be installed in an area that leaves
enough room to easily handle the size of your
workpieces.
If there is any tendency for the table saw to tip
over, slide or move during operation, the table
saw should be secured to the floor.
Storing accessories
1
014519
Push stick and wrenches can be stored on the right side
of the tool.
1
1. Hook
1
1. Push stick

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Adjusting the depth of cut
1
014520
The depth of cut may be adjusted by turning the handle.
Turn the handle counterclockwise to raise the blade or
clockwise to lower it.
NOTE:
Use a shallow depth setting when cutting thin
•
materials in order to obtain a cleaner cut.
Adjusting the bevel angle
014521
Loosen the lock knob counterclockwise and the desired
angle (0° - 45°) is obtained. The arrow pointer indicates
the bevel angle.
After obtaining the desired angle, tighten the lock knob
clockwise to secure the adjustment.
CAUTION:
After adjusting the bevel angle, be sure to tighten
•
the lock knob securely.
Switch action
CAUTION:
Remove workpiece from the table.
•
Before plugging in the tool, always be sure that the
•
tool is switched off.
7
1. Handle
1. Lock knob
2. Arrow pointer
1
2