Carrying Tool; Optional Accessories; Maintenance - Makita 2712 Instruction Manual

2
014538
Slide the rip fence into the rail on the table. Loosen the
knob on the fence and align to desired angle (0° to 60°).
Bring stock flush up against fence, secure it with the
clamp on the rip fence and feed gently forward into the
blade.

Carrying tool

014539
Make sure that the tool is unplugged.
Carry the tool by holding the tool part shown in the figure.
CAUTION:
Always secure all moving portions before carrying
•
the tool.
Always make sure that the blade guard is installed
•
in place before carrying the tool.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
If the push block handle or push sticks is broken,
•
contact Makita service center to get the replacement.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may result.
Cleaning
Clean out sawdust and chips from time to time. Carefully
clean the blade guard and moving parts inside the table saw.
1. Rip fence
2. Knob
1

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Rip fence
•
Wrench
•
Hex wrench
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
11
or attachments
Only use accessory or
are