Probe Setup - Zynex Medical InWave User Manual

Step 1 Remove probe from package.
Note: Only use probes approved by Zynex Medical that are
compatible with the InWave.
P/N 400024 is provided as a standard accessory.
(Manufacturer's P/N PR-03J)
See Page 27 for optional probes.
Step 2 Insert vaginal probe into the vagina as shown in Fig. 1 on page 10.
If needed, a small amount of water-based lubricant should be
applied to the tip of the probe to aid in insertion. Initial placement
of the vaginal probe and selection of the treatment program should
be performed under the guidance of a physician. Note: Overuse
of lubricant can cause lack of stimulation, and lead to ineffective
treatment.
CAUTION: Do not insert or remove the probe when the device
is on. The device must be turned off prior to insertion or removal
of the probe.
See the directions included with the probe for further information.
Note: Vaginal probes are for single patient use only.

Probe Setup

9