Operating Instructions - Zynex Medical InWave User Manual

Start Treatment:
Before starting treatment, the probe must be inserted in the vagina and the
probe connector must be plugged into the opening on the top of the device.
See pages 9-11 for instructions.
1. Turn InWave on by pressing the On/Off button.
2. Set the desired program using the Modality and Program buttons.
3. Increase the stimulation level by pressing the Intensity Up button until a
strong but comfortable stimulation level is felt.
4. Once the desired level of stimulation is set, the unit will automatically shut
off at the preset treatment time shown on the display. If the Treatment
Timer has been set to No Timer then the device will need to be shut off
manually. Refer to Programming Instructions on page 12 to adjust the
Treatment Timer.
4. To turn off the device manually press the On/Off button.
Note: If "Check Connections!" message is displayed on the screen, see "Display Alerts",
Page 16 and "Troubleshooting", Page 26.
During Treatment:
Note: The user should assume a seated, reclined, supine or standing relaxed
position, depending upon preference and/or level of comfort.
IMPORTANT: Button controls lock out after 20 seconds of inactivity. To
unlock button controls, press the Unlock button.
Increase Intensity:
To increase intensity press the Up Intensity button until the desired level of
stimulation is felt.
Decrease Intensity:
To decrease intensity press the Down Intensity button until desired level of
stimulation is felt.

Operating Instructions

15