Table of Contents
Advertisement
4.
Lubrication Oil
4-1 Lubrication Oil
Use YAMATO SF OIL 28
4-2 Feeding Oil
As the oil in the machine is drained completely at the
time of shipment, replenish oil to the upper line of Oil
Sight Gauge② by removing Seal Plug① indicated "OIL"
before operating the machine without fail.
4-3 Oil Sight Gauge and Nozzle
Check Oil Sight Gauge ② before operating machine
everyday. If the oil surface is below the two lines, supply
oil.
Make sure that oil flows out of Nozzle③ at the start of
operation.
4-4 Oil Change
For the long life of machine, change lubrication oil
completely after 250 hours of initial operation.
Oil
change
should
procedure.
1. After removing V-Belt from Motor Pulley, remove
Machine Head out of Machine Table.
2. Remove Screw④ and drain oil. At this time, be careful
not to smear V-Belt.
3. After draining, tighten Screw④ without fail.
4. When replenishing oil, refer to para "4-2 Feeding Oil".
be
made
following
－4－
the
next
①
③
②
④
Hide quick links:
Advertisement
Table of Contents
