Troubleshooting - Dual XD230M Installation & Owner's Manual

XD230M OPERATION

Troubleshooting

Problem
Unit will not turn on
(no power)
Unit has power
(but no sound)
Unit blows fuses
Unit will not tune, seek or
autostore (AS/PS) stations
Excessive skipping
ERROR 1 appears
on display
ERROR 2 appears
on display
Unit will not accept
a disc
Unit will not eject
a disc
10
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage
Black wire not connected
Fuse blown
Speaker wires not connected
One or more speaker wires touching each
other or touching chassis ground
Yellow or red wire touching chassis ground
Speaker wires touching chassis ground
Incorrect fuse rating
Unit has Manual Tuning Lockout feature
enabled
Unit is not mounted correctly or backstrap is
not secure
Physical defect in media (CD, CD-R or CD-RW) Check media for scratches
Disc read error
Focus error or disc is in upside down
CD mechanism position out of alignment
CD transit screws still in place
Unit has Eject CD Lockout feature enabled
CEA-2006 Power Standard Specifications
(reference: 14.4VDC +/- 0.2V, 20Hz~20kHz)
Power Output: 18 Watts RMS x 4 channels at 4 ohms and < 1% THD+N
Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms)
Cause Action
Check connections for proper
voltage (11~16VDC)
Check connection to ground
Replace fuse
Check connections at speakers
Insulate all bare speaker wires from
each other and chassis ground
Check for pinched wire
Check for pinched wire
Use fuse with correct rating
See your supervisor for the code
Check mounting sleeve and
backstrap support
Press EJECT
Press EJECT
Press and hold EJECT for 3 seconds
to reset CD mechanism position
Remove 2 transit screws located on
top of the unit
See your supervisor for the code