Automatically Turning The Machine Off (Auto Power Off) - Oki C542 User Manual

• MIB*
*References with some supported MIB (the Get command) are possible in Deep Sleep
mode.
In Deep Sleep mode, the following protocols that have the client function do not operate.
• E-mail alert* 2
• SNMP Trap
• WINS* 1
• SNTP* 2
*1
The elapse time in Deep Sleep mode is not included in the intervals of WINS update
time.
WINS regular updates are not performed in Deep Sleep mode, possibly resulting in
names that are registered in the WINS server being deleted.
*2 The elapse time in Deep Sleep mode is not included in the intervals of the e-mail alert
notification time and the intervals of the NTP server update time.
In a network environment where a large number of packets are sent, the machine
automatically exits Deep Sleep mode to Sleep mode and responds.
Also, if a terminal that runs searches with Bonjour, such as Mac or iPhone, is connected to
the same network, the machine automatically exits Deep Sleep mode to Sleep mode and
responds.
This machine automatically enters Deep Sleep mode after a certain period of time.

Automatically Turning the Machine Off (Auto Power Off)

The machine equipped with the Auto Power Off function which automatically turns the power
off if the machine is left unoperated for a certain period of time.
There are three options for the Auto Power Off setting and [Auto Config] is set by factory
default.
• [Auto Config]: The machine automatically turns off after being left unoperated for a certain
period of time unless the machine is in the following conditions.
- A LAN cable is connected to the network interface connector.
- Wireless LAN is enabled.
• [Enable]: If you do not use the machine for a certain period of time, the machine
automatically turns off.
• [Disable]: Disables the Auto Power Off function. The machine does not automatically turn
off.
The machine does not automatically turn off in the following case.
• When an error has occurred
Follow the steps below to change the Auto Power Off setting.
1
Press [Device Settings] on the touch panel.
2
Press or several times and press [Admin Setup].
3
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "999999"
respectively.
4
Press or several times and press [User Install].
5
Press [Power Setup].
6
Press [Auto Power Off].
7
Select the value.
- 119 -
7. Management/Specifications