Table of Contents
Advertisement
PLA 240 Small Room Loop Amplifier
Product Overview
An enhanced microprocessor controlled loop amplifier with outstanding sound quality
designed to be used with modern audio and video products to transmit the sound directly
to your hearing aid. Your hearing aid must be switched to the "T" or Loop function to use
the loop system. You can also enjoy the benefits of the loop amplifier by simply plugging
in a set of headphones into the headphone jack on the rear of the amplifier. For best
results connect the amplifier directly to your TV or other sound source using the RCA
Cable supplied.
Setup
The loop system is supplied ready for use with the following items:
- 1 Loop Amplifier
- 1 Remote Control with battery
- 1 Stand
- 1 Power Supply with line cord.
- 1 Digital Audio optical TOSlink and Coaxial Cables
- 1 Analog audio kit: 1.2 m RCA-RCA cable, SCART-RCA and 3.5mm stereo jack-RCA adapters.
- 1 Microphone with Velcro
pads.
™
- 1 Spool of 130 ft (40 m) of Loop Wire and 1 pack of 50 wire clips
- 1 Warranty/Guarantee Card
- 1 Operating Instructions
Important: Always disconnect the unit from power before making connections.
Loop Amplifier
Place the amplifier in a convenient well ventilated area near the TV or other audio source
such that al the necessary connections can reach the relevant device. The optional stand
may be used to mount the unit vertically if required.
Place Loop Wire around Listening Area
Run the loop wire around the room starting and ending at the amplifier. The wire may be
tucked under the edge of the carpet, or fixed to either a picture/dado rail or skirting board
with the clips provided. Where a cable passes a door or other obstacle, either fix the
cable around the frame or tuck it under the carpet. The cable just needs to go around the
area that needs to be looped, it does not necessary to go up and over doors or windows
or around fireplaces.
Important: Excess loop wire may be cut off, but a minimum of 35 ft (11 meters) must be
Advertisement
Table of Contents
