Craftsman 315.218060 Operator's Manual page 27

TO USE OUTFEED SUPPORT
See Figure 31.
The outfeed support slides to give the operator additional
support for cutting long workpieces.
n With the table saw in the OFF position, stand behind the
saw.
n Grasp the outfeed support with both hands and pull it
until it is fully extended.
TO USE THE TABLE EXTENSION
See Figure 32.
The table extension provides the operator with additional
table width for supporting wider workpieces.
To extend:
n Push the table extension lever beneath the saw table
towards the back of the saw.
n Grasp the table extension with both hands and pull
it until the scale on the front rail indicates the desired
measurement.
n Retighten the table extension lever by pulling it towards
the front of the saw.
To close:
n Push the table extension lever beneath the saw table
towards the back of the saw.
n Push the table extension with both hands back toward
the saw table.
n Retighten the table extension lever by pulling it towards
the front of the saw.
OPERATION
OUTFEED
SUPPORT
27
TABLE
EXTENSION
LEVER
LOWER
SCALE
Fig. 31
19 in.
MARK
Fig. 32