Troubleshooting - Keurig K150C Owner's Manual

SECTION 5
SITUATION SOLUTION
Brewer does not Plug the brewer into an independent socket.
•
have power Check to be sure that it is plugged in securely.
•
Make sure that the brewer is powered on and
•
LCD Screen is illuminated.
Reset circuit breaker if necessary.
•
Plug into a different socket.
•
Brewer will After placing the K-Cup
•
not brew holder, make sure the handle is pushed down
securely and the LCD Screen reads "READY TO
BREW" with the BREW Button flashing, then press
the BREW Button.
The exit needle may be clogged (refer to page 13).
•
LCD Messages
• If the water flow has been interrupted, LCD Screen
will state "WATER FLOW INTERRUPTED, TO
RESET, PLEASE PRESS BREW BUTTON". Press
BREW Button to resolve this issue.
• If the messages persist after following these
instructions, contact your Keurig Authorised
Distributor.

Troubleshooting

pod in the K-Cup pod
® ®
SITUATION SOLUTION
Chlorine or mineral Be sure to use filtered water. If you have any
•
taste in coffee questions, contact your Keurig Authorised
Distributor.
Brewing a
The exit needle may be clogged (refer to
•
partial cup page 13).
Clean the K-Cup
•
and rinse under tap (refer to pages 12-13).
"Descale" the brewer (refer to pages 13-14).
•
If you have repeated the descale procedure on
•
your brewer twice and it is still only
brewing a partial cup, contact your Keurig
Authorised Distributor.
If any problems persist, contact your Keurig Authorised Distributor.
16
pod holder assembly if necessary
®