Radio Thermostat ct100 User Manual page 51

Confi guration Parameters
This device supports the following Confi guration Parameters:
Name
1 Temp Reporting Threshold
2 HVAC Settings
3 Utility Lock Enable/Disable
4 C- Wire/Battery Status
5 Humidity Reporting Threshold
6 Auxiliary/Emergency
7 Thermostat Swing Temp
8 Thermostat Diff Temp
9 Thermostat Recovery Mode
10 Temp Reporting Filter
11 Simple UI Mode Enable/Disable
12 Multicast Enable/Disable
1. Temperature Reporting Threshold (8-bit)
This value determines the reporting threshold when association
reporting is enabled. Unsupported values are ignored.
Value
0
Treshhold
Disabled
2. HVAC Settings (32-bit)
Byte 1 = HVAC Setup: Normal (0x01) or Heat Pump (0x02)
Byte 2 = Aux Setup (Gas (0x01) or Electric (0x02)) & Number of
Auxiliary Stages (Heat Pump)/Number of Heat Stages
(Normal)
Byte 3 = Number of Heat Pump Stages
Byte 4 = Number of Cool Stages
3. Utility Lock (8-bit)
If set to 0, the utility lock is disabled. All other values (1-255) enable
the utility lock.
Set/Get
Set/Get
Get Only
Set Only
Get Only
Set/Get
Set/Get
Set/Get
Set/Get
Set/Get
Set/Get
Set/Get
Set/Get
1 2
Disabled 0.5°F
CT100 Thermostat
Z Wave
Default Values
2
N/A see below
0 0 to 127
N/A
2
0
2
4
2
see below
1
0
3 4
1.0°F 1.5°F
®
0 to 4
0 or 1
0 to 3
0 or 1
1 to 8
4 to 12
1 or 2
0 or 1
0 or 1
51