Radio Thermostat ct100 User Manual page 49

Z-Wave Reference
®
The CT100 can work in the same network with any other certifi ed
Z-Wave device, regardless of manufacturer/vendor. See your specifi c
Z-Wave® controller's User Manual for detailed instructions on
operating your thermostat through the network.
Behavior Note: When power is fi rst applied to this device
it will broadcast a Hail message followed by a Node
Information frame. This behavior is to maintain backwards
compatibility with older controllers that work with this line
of devices.
Z-Wave Lifeline
The following commands can be sent to lifeline:
• Command Class Sensor Multilevel - Sensor Multilevel Report
• Command Class Basic - Basic Report
• Command Class Thermostat Mode - Thermostat Mode Report
• Command Class Thermostat Operating State - Thermostat
Operating State Report
• Command Class Thermostat Fan Mode - Thermostat Fan Mode
Report
• Command Class Thermostat Fan State - Thermostat Fan State
Report
• Command Class Thermostat Setpoint - Thermostat Setpoint Report
• Command Class Multichannel - Multi Channel Command
Encapsulate
These can be accessed via an Association Group Info Command List
Get for group 1 (lifeline)
Advanced Z-Wave
The CT100 supports compliant mapping of the Z-Wave
COMMAND_CLASS to the CT thermostat "Energy Saving" and
"Comfort Mode" as follows:
• Basic Set (Value = 0x00) = Set Energy Saving Mode
• Basic Set (Value = 0x01-0x63 & 0xFF) = Set Comfort Mode
Energy Savings applies a 4° F setback to the existing set point
temperature to comply with EPA recommendations for energy
savings.
Information
®
CT100 Thermostat
Z Wave
BASIC_
®
®
49