Cleaning And Maintaining The Device; Faults And How To Remedy Them; Technical Data - NUK Smart Control Multi 310 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

8. Cleaning and maintaining the device

Warning! To avoid the risk of
electric shock, injury or damage:
– Always disconnect the camera
network cable from the power
socket
device.
– Never immerse the individual
parts in water.
Caution! Under no circumstances use
abrasive, corrosive or scratching cleaning
agents, as these could damage the device.
Fault
Sound but no
picture is
transmitted
No image from the
camera is shown,
just the list of
available cameras
No alarm message
is sent to the
smartphone
Image sensor
Video illumination
Compression
Resolution
White balance
Audio
Temperature sensor
Operating temperature
Storage temperature
Air humidity
Power input
Mains connection
before
cleaning

9. Faults and how to remedy them

Cause
The bandwidth (data transmission
rate) of the connection is
inadequate
The UID has not been transmitted
correctly
Messages have been switched off Switch on messages (see "6.1.2 Inputting

10. Technical data

CMOS
8 infra-red LEDs
Min. 3 LUX light intensity
Baby's face clearly visible within 2 metres
H.264
640X480 VGA or QVGA
Automatic
Two-way talk function via analogue microphone and loudspeaker at
0.5 W, 16 kHz
NTC type, 10 kΩ at 25 °C; deviation +/- 2 °C
0° C to 40° C ambient temperature
-20 ° C to 70 ° C ambient temperature
40 to 90% rH (no condensation)
External DC 5.8 V - 1000 mA
EU specifications 100 ~ 240 V 50/60 Hz
1. If necessary, wipe the individual parts
with a suitable cleaning cloth.
Note: you can moisten the cleaning cloth
slightly (mist it) if the parts are very dirty,
the
but no liquid may get into the device.
1. Only use the baby phone again when all
the parts have fully dried out.
2. Carefully clean the camera lens when
necessary with a soft cloth, e.g. tissue for
cleaning spectacles.
Set camera settings to the lower values (see
"7.2.3 Camera settings" on page 33).
Enter camera data using QR code or by
hand (see "6.1.2 Inputting camera data
manually" on page 28).
camera data manually" on page 28).
Camera
35
Remedy

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Smart Control Multi 310 and is the answer not in the manual?

Questions and answers

Table of Contents