Printing Configuration Report; Reset The Printer To Factory Default - Paxar MO 9742 Operator's Manual

8. Printing Configuration Report

1. Hold down the feed button while turning on the power, until the
printing motor becomes activated.
2. After feeding 12-inch blank media, the printing motor will
suspend for one second, then it will print out the configuration
profile. This profile states the firmware version, ROM checksum,
RS232, thermal transfer/direct thermal settings, hardware
configuration and font types.
3. With PPLB emulation, the printer will enter character dump
mode. To exit from dump mode, just re-start the printer again.
32
MO9740 Manual

9. Reset the Printer to Factory Default

1. Turn on the printer and wait for 5 or more seconds.
2. Press the feed button for about 10 seconds; the ready indicator
and the power indicator will then go off in order.
3. While both indicators are lit again, release the feed button.
4. At this point, the printer will begin to feed the label stock for
approximately 12 inches in length, and return to the factory
default settings.
Note :
All settings are stored in non-volatile E2PROM and
cannot be destroyed even turn off the printer.
MO9740 Manual
33