OEM RHPC-HD10 Operational Manual page 15

DCC-SC01HD32
BLC WINDOW SET
Items SELECT
window0～
7x7(49)
Window window48
MASK
SET/CLR
BLEMISH COMP.
Items SELECT
USER DISP.
COMP.
START
ERROR
START 16-127
LEVEL
MAX. QTY 4-63
CAM TITLE EDIT
Items SELECT
Character ABCDEFGH
Selection IJKLMNOP
QRSTUVW
XYZ
abcdefghijk
lmnopqrstu
vwxyz-.,()0
123456789
Usage Method of Auto Iris Lens
This camera outputs signals for auto iris so that Video Iris lenses can be connected.
Here, we would like to explain how to adjust variable resister installed in the Video Iris lenses.
Please refer to the Section 7, External Connector Pin Assignment, for connection.
First of all, set GAIN OFF and SHUTTER OFF, then set AESET >AE RESPONS with OSD menu.
Try to shoot the area as blight as possible, set the ALC volume to Av side, and then, adjust the level volume
of lens-side, trying to position the Icursor of IRIS LEVEL to be center.
After adjusting, restore GAIN and SHUTTER settings to be used. When adjusting blightness, please do not
use lens-side volume. Adjsut the blightness with AE LEVEL after the explained adjustment is completed.
If lens-side volume is forced to use to adjust blightness, AGC and AES would not work properly in
conjunction with the other.
Next menu Explanation
Set Mask ON/OFF for back light.
The masked area (whiteout part) will not be reflected by auto
exposure. [D]: to MASK ON and goes to the next area.
[U]: to MASK OFF and goes to the next area.
Next menu Explanation
Indicate the corrected are by pixel defect correction (White spot)
with blinking.
Start detection of pixel defect area (White spot) with sheilding
and blacking-out the entire lens.
With successfully completed, transmit to DISP and display the
area to be corrected with blinking.
If not successfully completed, transmit to ERROR.
If not shielded or max q'ty is too low, ERROR might occur.
In such case, shiled completely and increase the max q'ty to
restart.
Set the beginning level to start detection.
The level will go higher gradually from this level.
Set the maximum q'ty to detect.
The q'ty to be detected shall be less than this q'ty.
If there are too many areas to be corrected, reduce this q'ty.
Next menu Explanation
[U], [D] to select characters, and [ENTER] to shift the character
position to edit to the right.
-
14
Rev.900-717-30-00