Epson PictureMate PM-401 User Manual page 61

User's Guide
1. Install Epson iPrint on your smart device from the following URL or QR code.
http://ipr.to
2. Check the printer's IP address.
Check the IP address from the network status screen on the printer's control panel.
3. Run Web Config by entering the printer's IP address in the browser on your smart device.
Note:
See the manual provided with your smart device for the operating instructions.
4. Select Advanced Settings > Services > Wi-Fi Direct.
5. Select Connect to the Wi-Fi Direct devices only from Connection Mode.
6. Press Next, check the settings, and then press OK on the next screen.
Note:
The printer is set to connect in Wi-Fi Direct mode. This setting is available until the next time you change the mode
setting. You do not need to make settings every time.
7. Select Wi-Fi Setup on the printer's home screen, and then press the OK button.
8. Select Wi-Fi Direct, and then press the OK button.
9. Press the OK button after checking the message.
10. Press the OK button after checking the message.
11. Check the alert message, and then press the OK button.
Connecting the Printer to the Smart Device or Computer
61