CONTENTS Safety information Care and cleaning Safety instructions Troubleshooting Operation Installation Daily Use Noises Hints and tips Technical information Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
Do not use mechanical devices or other means to accelerate • the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer.
Page 4
electrician to change the electrical • Do not freeze again food that has been components. thawed. • The mains cable must stay below the • Obey the storage instructions on the level of the mains plug. packaging of frozen food. •...
OPERATION Control Panel Display Mode Temperature warmer button ON/OFF Temperature colder button It is possible to change predefined sound of To reset the alarm refer to "High buttons to a loudly one by pressing temperature alarm". together Mode and temperature colder To select a different set temperature refer to button for some seconds.
FastFreeze function It is possible to change the time during the countdown and at To switch on the FastFreeze function : the end by pressing the 1. Press Mode button until the Temperature colder button and corresponding icon appears. the Temperature warmer button. The FastFreeze indicator flashes.
DAILY USE Cleaning the interior compartment let the appliance run at least 2 hours on the higher settings. Before using the appliance for the first time, wash the interior and all internal In the event of accidental accessories with lukewarm water and some defrosting, for example due to a neutral soap so as to remove the typical power failure, if the power has...
• A faint click noise from the temperature avoiding a rise in temperature of the regulator when the compressor switches latter; on or off. • lean foods store better and longer than fatty ones; salt reduces the storage life Hints for energy saving of food;...
The equipment has to be cleaned regularly: compartment, driven by an automatically controlled fan. 1. Clean the inside and accessories with lukewarm water and some neutral soap. Periods of non-operation 2. Regularly check the door seals and wipe clean to ensure they are clean and When the appliance is not in use for long free from debris.
Page 10
Problem Possible cause Solution The temperature in the ap- Contact a qualified electrician pliance is too high. or contact the nearest Author- ised Service Centre. The compressor operates Temperature is set incor- Refer to "Operation" chapter. continually. rectly. Many food products were Wait some hours and then put in at the same time.
Problem Possible cause Solution The food products' tem- Let the food products tempera- perature is too high. ture decrease to room temper- ature before storage. The door has been opened Open the door only if necessa- often. The FastFreeze function is Refer to "FastFreeze function".
current regulations, consulting a qualified 5. Tighten the lower pin on the opposite electrician. side. • The manufacturer declines all responsibility if the above safety precautions are not observed. • This appliance complies with the E.E.C. Directives. Ventilation requirements The airflow behind the appliance must be sufficient.
Page 13
8. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in 4. Push the appliance in the direction of opposite case. the arrows (2) against the cupboard on the opposite side of the hinge.
Page 14
15. Open the appliance door and the kitchen furniture door at an angle of 10. Install the vent grille (B). 90°. 11. Attach the hinge covers (E) to the hinge. 16. Insert the small square (Hb) into guide 12. Disconnect the parts (Ha), (Hb), (Hc) (Ha).
21. Press the part (Hd) on the part (Hb). 8 mm 19. Place the small square on the guide again and fix it with the screws Do a final check to make sure that: supplied. • All screws are tightened. 20.
TECHNICAL INFORMATION Technical data Dimensions of the recess Height 1780 Width Depth Rising time Hours Voltage Volts 230 - 240 Frequency The technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENT CONCERNS dispose appliances marked with the symbol Recycle the materials with the symbol...
Need help?
Do you have a question about the S7220FNDP and is the answer not in the manual?
Questions and answers