Specifications - Makita DTD134 Instruction Manual

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star mark
3-1. Indicator lamps
3-2. Check button
4-1. Switch trigger
5-1. Lamp
6-1. Reversing switch lever
7-1. Button

SPECIFICATIONS

Model
Machine screw
Capacities Standard bolt
High tensile bolt
No load speed (min
Impacts per minute
Overall length
Rated voltage
Battery cartridge
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model DTD134
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model DTD146
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Explanation of general view
7-2. LED indicator
9-1. Bit
9-2. Sleeve
10-1. Bit-piece
10-2. Bit
11-1. Hook
11-2. Screw
13-1. Limit mark
14-1. Screws
14-2. Rear cover
-1
)
BL1415 / BL1415N
1.2 kg
) : 92 dB (A)
pA
) : 103 dB (A)
WA
) : 93 dB (A)
pA
) : 104 dB (A)
WA
DTD134
4 mm - 8 mm
5 mm - 14 mm
5 mm - 12 mm
0 - 2,400
D.C. 14.4 V
BL1430 / BL1440 /
BL1450
1.4 kg
ENE033-1
Model DTD134
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
ENG905-1
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DTD146
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 2.0 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENG900-1
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
4
15-1. Spring
15-2. Arm
15-3. Recessed part
16-1. Carbon brush cap
17-1. Lead wire
17-2. Carbon brush cap
18-1. Hole
18-2. Carbon brush cap
DTD146
0 - 2,300
0 - 3,200
138 mm
D.C. 18 V
BL1815 / BL1815N /
BL1820 / BL1820B
1.3 kg
) : 12.0 m/s
h
2
) : 15.5 m/s
h
2
BL1830 / BL1840 /
BL1840B / BL1850 /
BL1850B
1.5 kg
2
2
ENG901-1