Table of Contents
Advertisement
Installation
Installation site
,
Make sure the dryer door can be
opened without hindrance after
installation.
Transporting the machine to its
installation site
When moving the machine you can
hold it by the lid where it protrudes to
the rear of the dryer. To manoeuvre the
dryer out of its packing case to its
installation site you will also need to
hold it by the front feet.
Building under a continous worktop /
in a row of kitchen units
The dryer should not be installed
next to a refrigerator or freezer. The
warm air expelled from the rear of
the dryer would increase the
temperature around the
refrigerator's/freezer's heat
exchanger causing the compressor
to run continuously. If it is not
possible to install the dryer
anywhere else, then the
refrigerator/freezer must be sealed
off from the dryer.
– A special conversion kit* is required.
The machine lid is replaced by a
coverplate which must be fitted by
suitably qualified person to ensure
electrical safety.
– When installing under a 900/910 mm
high worktop a spacer kit* is
required.
38
– The electric socket must be located
in an accessible position near the
machine.
When built under running times may be
longer.
NOTE:
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid, the conversion
kit is not necessary. Otherwise the
conversion kit is essential.
When building under allow for 625 mm
to include hoses, lid, facia and door.
When building the machine in behind
cabinet doors, ensure that doors are
open during operation for adequate
ventilation.
Replacing the lid
If the lid has been removed in order to
fit a cover plate, ensure that, if the lid is
replaced, it fits securely into the rear
holders. Otherwise, it is not properly
secure for transport.
Hide quick links:
Advertisement
Table of Contents
