Miele T 4453 C Operating Instructions Manual page 16

How to dry correctly
E Start the programme
^ Press the Start/Stop T button.
– The indicator light for the
Start/Stop T button will then change
from flashing to being on constantly.
– A few seconds later, the programme
time remaining will appear in the
display.
– The SEQUENCE indicator light for
the drying stage reached will come
on.
Memory function (for Programme
selection)
The electronics will store in memory the
drying level and any Extras selected for
the current drying programme.
The next time you chose that
programme the indicator lights for
these settings will come on. You can
accept these or change them by
pressing a button.
The memory function is deactivated if
the programme is cancelled. If the
buzzer has been selected, this
selection will be saved automatically,
whether or not the memory function has
been activated.
Before the end of a programme
There is a cooling down phase (Cool
air) at the end of the drying sequence.
The programme will not finish until the
cooling down phase has been
completed.
There is no cooling down phase at the
end of the following programmes:
Woollens handcare, Smoothing.
16
At the end of a programme
The indicator light Anti-crease / Finish
comes on. The indicator light for the
drying stage reached (depending on
the programme selected) will also
come on.
0 will appear in the display.
F Remove the laundry
^ Press the Door button.
^ Open the door.
^ Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
^ Switch the dryer off by pressing the
l-On/0-Off button.
^ Clean the fluff filters.
^ Close the door.
^ Empty the condensed water
container (where there is no external
drainage of the water).
^ The condenser unit should be
checked and cleaned on a regular
basis.