Power Connector Location On Rear Panel; Connecting To External Power Source - Patton electronics SmartNode 2294 Getting Started Manual

Model 2292 & 2294 Series Getting Started Guide

Connecting to external power source

The extender comes with an external power supply. This section describes installing the power cord into the
extender. Do the following:
Note Do not connect the power cord to the power outlet at this time.
1. Insert the barrel type connector end of the AC power cord into the external power supply connector (see
figure 12).
External power supply connector (accepts 12 VDC, 1.25 A, from external AC adapter)
, 1.25A
2. Verify that the AC power cord included with your extender is compatible with local standards. If it is not,
refer to "Contacting Patton for assistance"
power cord.
3. Connect the male end of the power cord to an appropriate power outlet.
Installing the SmartNode extender
Reset ETH 0/1 ETH 0/0
Figure 12. Power connector location on rear panel
The extender power supply automatically adjusts to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
on page 38 to find out how to replace it with a compatible
3 • Hardware installation
Ports
, 1
.2 5
A
R e
s e
t
E T
H
0 /1
E T
H
0 /0
P o
r ts
30