Encoder Status Commands - EEG HD490 Manual

HD490 Smart Encoder

Encoder Status Commands

Report Identification <CTRL+A>? <ENTER>
Report Port Activity
Modem Status
Recovery Status
SD Video Presence
Report Switch Setting <CTRL+A>S <ENTER>
Report Battery Level <CTRL+A>Y <ENTER>
Returns the Encoder's model, serial number, and firmware version.
<CTRL+A>O <ENTER>
Returns a table displaying which ports last entered data for each data
type. The port that last entered data for each data type is marked with an
A in the table. The data types are primary language captioning (CF1),
secondary language captioning (CF2), primary text services (TF1),
secondary text services (TF2), and XDS.
<CTRL+A>+ [Modem] <ENTER>
Returns the status of the specified modem as either On Hook or Off
Hook. The Modem parameter need not be entered to view the status of
MA, the built in dial up modem.
<CTRL+A>A <ENTER>
Returns the data recovery status of each Line 21 channel for incoming
SDI video. ON indicates that data on the channel is being recovered and
processed. OFF indicates that the channel has been turned off (see page
19) and incoming data is being ignored.
<CTRL+A>b <ENTER>
Reports either Video Present or No Video Present to indicate whether or
not the Encoder is receiving an SDI video signal.
Returns the current setting of the front panel INSERT ON bypass
switch.
Returns the status of the battery that maintains the Encoder's Non-
Volatile Memory. GOOD will be returned for a properly functioning
battery. BAD will be returned for a battery in need of replacement.
Copyright © 2000-2012 EEG Enterprises, Inc.
All Rights Reserved.
42