EEG HD490 Manual page 29

Digital smart encoder
Hide thumbs Also See for HD490:
Table of Contents

Advertisement

HD490 Smart Encoder
Load NVM XDS packet
Report XDS Queue
packet (two Space characters), the Encoder will continue insertion of the
discontinued packet for a time-out period of 5 minutes to ensure
continuity during commercial breaks or replacement delays. The default
packet will then be transmitted until the upstream packet is replaced.
The Packet, Duration, and Content parameters are the same as for the
local priority Load XDS Packet command explained on the previous
page, except the Packet Class/Type must be entered with a leading "L".
 Holdoff sets the number of seconds after which the default packet
will begin transmission once the five minute upstream time-out
period expires. The default is zero.
Example
: <CTRL+A>P L105 –1 4840 <ENTER> will create a default
program rating packet of None. This packet will be inserted beginning 5
minutes after an interruption in upstream program rating data, and will
continue to be transmitted indefinitely until upstream data resumes.
<CTRL+A>w <CTRL+A>P Packet -1 Content <ENTER>
Stores an XDS packet in Non Volatile Memory. The stored packet will
be loaded into the XDS queue every time the Encoder starts up, and will
be inserted indefinitely unless cancelled. The packet will not initially be
sent to the queue until the Encoder is rebooted.
NVM storage is suggested for packets like Network Name, Station ID,
and TSID that do not need to be updated, or for default packets. To
change or delete an item in NVM, see page 34. Note also that only P3
may write to the NVM.
Example
: <CTRL+A>w <CTRL+A>P 502 –1 {WEEG} <ENTER>
stores a Station ID packet reading "WEEG" in NVM. Once the Encoder
has been rebooted, this packet will be sent indefinitely whenever the
Encoder is on.
<CTRL+A>e [Packet] <ENTER>
Reports the contents and settings for the packet of the specified
Class/Type loaded in the XDS queue. An asterisk after the packet ID
indicates that max time-based preemptive priority has been set. If the
Packet parameter is omitted, the entire XDS queue will be displayed.
The following information is displayed:
Copyright © 2000-2012 EEG Enterprises, Inc.
All Rights Reserved.
28

Advertisement

Table of Contents
loading

Table of Contents