Web Configuration - EEG HD490 Manual

HD490 Smart Encoder

Web Configuration

The Web Configuration interface enables you to access configurations
and log files for your 490 applications from any computer on your local
network. Several web applications are installed at the factory for all
HD490 encoders: a Startup Setting editor, a web-based serial-emulation
Terminal for entering Smart Encoder commands, a documentation
library, and the iCap™ application.
To use Web Configuration, first connect the Ethernet connector on the
rear panel of the HD490 to your local network. Then, use the front panel
LCD and button pad to give the encoder a valid IP address and subnet
mask for your network by navigating to System Setup | Network Setup
| IP Address and System Setup | Network Setup | Subnet Mask.
Once you have set up the front panel IP settings, you can leave your
encoder and open up a web browser on any PC on the same local
network. Navigate to the IP address that you configured on the
encoder's front panel; for example, type 192.168.1.15 into the address
bar of the browser if that is the address you entered into the front panel.
If you cannot navigate to the page in your web browser, check with
your network administrator that the IP Address and Subnet Mask you
entered on the encoder front panel are valid parameters for your
network, since individual settings vary.
Copyright © 2000-2012 EEG Enterprises, Inc.
All Rights Reserved.
12