Jet-Vac Adjustments For Vinyl Liner Pools - Pentair Jet-Vac Installation Manual

Some vinyl pools have a steep incline from the deep end to the shallow end, some simple adjustments to the
JET-VAC will help it climb up into the shallow end of the pool.
1. Remove the transparent nose wheel (part # JV13) by removing the Phillips screw and the plastic
hub that the screw goes through. Turn the nose wheel upside down, with the flange end of the hub up,
reinstall the screw into the hub and screw securely. Check that it spins freely and does not fall off.
2. Remove the Phillips screw and nut that holds the stainless steel wheel (part # JV15) in place and reinstall
in the lower mounting position.
3. Loosen, but do not remove, the Phillips screw that attaches the roller arm (part # JV12) to the JET-VAC
body. Place the JET-VAC on a flat surface and adjust the roller arm angle so that the bottom of the
stainless steel wheel (JV15) is 1/2" from the flat surface and tighten the Phillips screw securely.
4. Test the JET-VAC in the pool to verify adjustments.
*Note: In some cases it may be necessary to increase pressure to 27-29 PSI for added thrust.
10
VINYL LINER POOLS - ADJUSTMENTS
JET-VAC INSTALLATION MANUAL