Siemens DP/AS-Interface Link 20E Manual page 109

152 Parameters slave 28
153 Parameters slave 30
154
155 Parameters slave 2B
156 Parameters slave 4B
157 Parameters slave 6B
158 Parameters slave 8B
159 Parameters slave 10B
160 Parameters slave 12B
161 Parameters slave 14B
162 Parameters slave 16B
163 Parameters slave 18B
164 Parameters slave 20B
165 Parameters slave 22B
166 Parameters slave 24B
167 Parameters slave 26B
168 Parameters slave 28B
169 Parameters slave 30B
170
171
Flag 1
Bit Number Meaning
0 OFFLINE_READY
1 APF
2 NORMAL_MODE
3 CONFIG_MODE
4 AUTO_ADDR_AVAIL
5 AUTO_ADDR_ASSI_GN
6 LDS_0
7 CONFIG_OK
Flags whose values modify the AS-i master mode are shown in gray. The values of
the other flags have no significance for the 'store total configuration' command and
cannot be modified on the AS-i master with this call..
CONFIG_MODE
AUTO_ADDR_ENABLE
DP/AS-Interface Link 20E
Release 11/2002
C79000-G8976-C138–04
reserved
Flag 1
Flag 2
The entry '0' means that the DP/AS-i Link 20E changes to the protected
mode after executing the command. The entry '1' means that the
configuration mode is retained.
0: On completion of the job, the AS-i master starts up in the protected mode.
1: On completion of the job, the AS-i master starts up in the configuration
mode..
'0' means that the automatic address programming is disabled, '1' means
that the automatic address programming is enabled.
0: Automatic address programming disabled.
1: Address programming enabled
Using the Command Interface
Parameters slave 29
Parameters slave 31
Parameters slave 1B
Parameters slave 3B
Parameters slave 5B
Parameters slave 7B
Parameters slave 9B
Parameters slave 11B
Parameters slave 13B
Parameters slave 15B
Parameters slave 17B
Parameters slave 19B
Parameters slave 21B
Parameters slave 23B
Parameters slave 25B
Parameters slave 27B
Parameters slave 29B
Parameters slave 31B
Flag 2
Bit Number Meaning
0 OFFLINE
1 INTERNAL
2 EEPROM_OK
3 AUTO_ADDR_ENABLE
4 PERIPHERY_FAULT
5 reserved
6 reserved
7 MPO startup
109