Connecting Power - Patton electronics CopperLink 2168 User Manual

3.5 CONNECTING POWER

An external AC or DC power supply is available separately. This connec-
tion is made via the barrel jack on the rear panel of the CopperLink
Ethernet Extender. No configuration is necessary for the power supply
(See Appendix B for domestic and international power supply and cord
options).
DC power (supplied via the power supply jack to the CopperLink Ether-
net Extender) must meet the following requirements; DC power supplied
must be regulated +5VDC ±5%, 1.0A minimum. Center pin is +5V. The
barrel type plug has a 2.5/5.5/10mm I.D./O.D./Shaft Length dimensions.
The CopperLink Ethernet Extender does not have a power switch, so it
powers up as soon as it is plugged in.
There are no user-serviceable parts in the Copper-
Link Ethernet Extender.Fuse replacement should
only be performed by qualified service personnel.
Contact Patton Electronics Technical support at (301)
975-1007 for more information.
WARNING
13