Step 12 Reinstall Front Glass - Lennox SEREFINA CI1500DVF series Installation Instructions Manual

4. Place the center log piece over the cor-
responding pins next to the front left log as
shown in Figure 23.
Figure 23
5. Install the right front log onto the cor-
responding burner pin and sub-fl oor right
tab as shown in Figure 24.
Right Front Log
Figure 24
6. Install the left top twig onto the correspond-
ing pin on the rear log and align it with the
indentation on the front left log as shown in
Figure 25.
Left Top
Twig
Figure 25
7. Install the center top twig onto the cor-
responding pin on the rear log and align it
with the indentation on front left log as shown
in Figure 26.
Center
Log
Piece
Figure 26
8. Install the front right twig onto the cor-
responding pin on the right front log. Align
the twig with the indentation on the front right
log as shown in Figure 27.
Figure 27
9. Place the glowing embers on the burner
as shown in Figures 28 and 29.
One package of ember material has been
included with this log set You will not need
to use the entire bag.
IMPORTANT: The quantity and placement of the
ember material can affect stove performance
therefore it is very important that it be placed
as shown in Figure
a. Unpackage and divide the fi ne ember material
(mineral wool) into dime-sized fl uffy pieces.
b. Distribute the pieces over the top of the
front burner ports avoiding covering the slots
(see Figure 29) and fi lling the area in front of
the forward logs.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Center
Top Twig
Right
Front Twig
s 28 and 29
.
Embers
Figure 28
DO NOT PLACE EMBERS ON TOP OF THE
BURNER SLOTS.
Figure 29
VERIFY THAT THE GAS LINE HAS BEEN
PURGED OF AIR (SEE STEP 10).
Step 12. RE-INSTALL FRONT GLASS
ENCLOSURE PANEL
(Reverse instructions on Step 4)
Retrieve the front glass enclosure panel.
Visually inspect the gasket on the backside
of the frame. Gasket surface must be clean,
free of irregularities and seated fi rmly.
With the stove top off, position the glass front
enclosure panel into the front opening with
the gasket facing the relief door (reference
Figures 8 and 9). Let the bottom of the door
frame gently slide down, then hook the top
fl ange of the glass frame over the top of the
fi rebox frame.
15