Neopost DS62 Operator's Manual page 38

Additional marks
When it is required to control more functions in the
inserter system, the use of more marks is needed.
The following additional functions are possible via
software options:
- divert mark
- stop mark
- 1 mark: selective feed from station 1
- 1 mark: selective feed from station 2
- 1, 2 or 3 marks: respectively sequence check
4, 2 and 1
- 1 mark: parity check mark (even)
- 1 mark: safety mark
General remarks:
- The marks must always be used in the above sequence.
- If a function is suppressed the following function will move upwards one line.
- The chosen code must always be used on all material which must be processed by
the Optical Mark Recognition.
- The length of the code and the mark definition is a service setting.
- Other marks/functions are possible via special codes (Flex codes)
Divert mark
The machine stops, manually remove the set from the collator. Reset and start again.
Stop mark
The machine stops, manually remove the set from the collator. Reset and start again.
Selective feed mark
The machine will selectively feed an enclosure when commanded so.
Sequence check
Sheets in a stack can accidentally get out of sequence or can be missing. This can be
detected by the sequence check.
Each sheet has a binary code that is a part of the reading code.
Parity mark
By adding a parity mark the reading code can be checked. When the OMR-2 code is used
the sum of the marks has to be even.
38
Start mark
Insert/accumulate
Divert mark
Stop mark
Selective feed 1
Selective feed 2
Sequence check 4
Sequence check 2
Sequence check 1
Parity (even parity)
Safety mark