Addendum #7: Clock Source Consistency In Cubase; Addendum #8: The Effect Of Routing Changes On Wave Drivers - Lexicon Studio Core2 Service Manual

Lexicon Studio Core2 Service Manual
sources and destinations of Punch are those which are enabled
(active) in Cubase. If, for example, you wish to route audio from the
Core2 A/D 1&2 to the Core2 D/A 1&2 you must activate the
corresponding input and output bus in Cubase. The Lexicon control
panel must be exited, then re-launched each time a change is made to
Cubase's active streams list.
When using the Wave drivers, if the Monitor button is turned on all
channels will be available for selection in the Punch and Reverb
source/destination lists. When the wave audio application is in play,
only the channels that it is using will be available to Punch and
Reverb routing. The same applies if the audio application has been
configured so that it keeps its audio channels open even when it is
in stop (see the specific application's User Guide for details on how
to set this up). When there is no audio application running, or the
application is in "stop" and has not been configured to keep the
audio channels open, all channels will be available to punch routing.
=====================================================================

Addendum #7: CLOCK SOURCE CONSISTENCY IN CUBASE

Whenever changing the clock source setting within Cubase, it is a
good practice to verify that the identical setting is selected in
the LexPanel clock source tab at that time. Any differences in these
settings could result in undesirable static. If such a condition
should occur, simply invoke the LexPanel from the task bar, and
Lexicon Studio will internally correct this problem.
=====================================================================

Addendum #8: THE EFFECT OF ROUTING CHANGES ON WAVE DRIVERS

If you are using the Wave drivers and make any changes to the Routing
Tab in the Lexicon control panel, you MUST restart Windows in order
to have these changes take effect. If the ASIO drivers are being used,
it is not necessary to restart Windows. Simply quit then re-launch the
audio application in order for the routing changes to take effect.
If you are using Cubase, for example, and see that some of the Input
or Output buses have a blank label, this is an indication that the
application must be restarted. If you are using Cubase and have
launched the Lexicon control panel from the Windows Taskbar, Cubase
must be quit before changes can be made to the Routing tab.
Note: at least one Input pair and one Output pair must be enabled
in order to launch Cubase. If no streams are active an error message
will come up saying that the ASIO Lexicon Studio Core-2 1.2 driver
could not be loaded. If this occurs, quit Cubase, launch the LexPanel
from the Windows Taskbar, turn on one or more I/O streams, then
re-launch Cubase.
=====================================================================
5-6