Pro-face GP-4100 series Installation Manual page 4

Panel Face
• Be sure that heat from surrounding equipment does not cause
the GP to exceed its standard operating temperature.
2. GP Installation
(1) Cut a hole in the panel according to the GP unit
panel cutout dimensions.
X
GP
GP X
+1
105.0
-0
GP-4100
Series
+0.04
[4.13
-0
(2) Confirm that the installation gasket is attached
to the GP unit and then place the GP unit into
the Panel from the front.
• GP unit has two projections
falling during installation. Please insert the GP unit into
the panel at an angle to avoid hitting the projections.
Projections
*1 GP units with Rev.1 or higher have projec-
tions. More information, please see the
nameplate on the GP unit.
• It is strongly recommended that you use the instal-
lation gasket, since it absorbs vibration in addition
to repelling water.
For the procedure for replacing the installation gas-
ket, refer to "GP-4100 Series Hardware Manual".
Inside Cabinet
r≤3 [0.12]
Panel
thickness
Unit: mm [in.]
Panel
Y
thickness
+1
1.0 [0.04]
66.0
-0
to
+0.04
5.0 [0.20]
] [2.60 ]
-0
*1
on the top to prevent
Insert GP at an angle.
• When mounting the GP unit vertically, ensure that
the left side of the unit faces up (i.e. the power
connector and serial interface should be at the
bottom).
Mounted
Horizontally
(3) Press the installation fastener hooks securely
into the insertion slots on the GP unit. (Press
the hooks in again to release the lock and
remove the installation fasteners.)
(4) Tighten the installation fasteners with a screw-
driver. There are two insertion slots on both the
top and bottom of the GP unit.
4
Front and Rear Views
when Mounted Vertically
(3)
Press the hooks
securely into
the insertion
slots.
(4)
Tighten the
screw with a
screwdriver
Top
Insertion Slots
Bottom