Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sase BULL 150
Summary of Contents for Sase BULL 150
- Page 1 BULL 150 VACUUM MANUAL SASE Company, Inc. 800.522.2606 │ www.SASECompany.com...
- Page 3 9 DO NOT GRASP PLUG WITH WET IMPORTANT SAFETY IN- HANDS. STRUCTIONS 10 A DAMAGED CORD OR PLUG should only be replaced by an authorized serv- READ ALL INSTRUCTIONS BEFORE US- ice center representative. DO NOT AT- ING THIS MACHINE. TEMPT TO REPAIR POWER CORD.
- Page 4 23 DO NOT USE IF CORD, PLUG, FIL- SAFETY INSTRUCTIONS TER, OR VACUUM CLEANER IS IN POOR CONDITION. If the Vacuum GROUNDING INSTRUCTIONS Cleaner has been dropped, damaged, This appliance must be grounded. If it exposed to weather, or dropped into should malfunction or break down, ground- water;...
- Page 5 Note: NEVER REMOVE GROUNDING PRONG In Canada, the use of a temporary adapter FROM POWER PLUG. is not permitted by the Canadian Electrical Code. EXTENSION CORDS Use only three-wire extension cords that Servicing of double-insulated appliances have three-prong grounding-type plugs and In a double-insulated appliance, two sys- three-pole receptacle that accepts the ap- tems of insulation are provided instead of...
-
Page 6: Table Of Contents
Please read and comply with Proper use these instructions prior to the – The machine is meant for dry and wet initial operation of your appliance. Retain cleaning of floors and walls. these operating instructions for future refer- – This appliance is suited for the commer- ence or for subsequent possessors. - Page 7 – If the appliance is used to vacuum wet Inserting the paper filter bag dirt the paper filter bag or the membrane filter (special accessory) must always be removed. – It is recommended to use a special filter bag (wet) (see Filter systems). Warning The flat pleated filter must must always be in place while vacuuming.
-
Page 8: Operations
Turn on the appliance (1). Operations Lamp is on - vacuum cleaner is in the stand- by mode (2). Turning on the Appliance Note – The vacuum cleaner is turned on and off automatically with the electric power tool. – The vacuum cleaner starts automatical- ly within 0.5 seconds and continues to run for 15 seconds after the power tool has been switched off. -
Page 9: Shutting Down
Empty the container. Vacuum and wipe the appliance inside and outside. Connect the adaptor to the electric pow- er tool. Automatic filter cleaning Store the suction hose and the mains The appliance has an innovative filter cable as shown in the illustration. cleaning system that is particularly effective Place the appliance in a dry room and with fine dust. -
Page 10: Troubleshooting
Cleaning the electrodes Dust comes out while vacuuming Check for proper installation of the flat pleated filter. Replace the flat pleated filter. Automatic shut-off (wet vacuum cleaning) does not react Clean the electrodes as well as the space between the electrodes. Continuously check the filling level in case of non-conductive liquid. -
Page 11: Warranty
In the event of a warran- ty claim please contact your SASE Representative Accessories and Spare Parts – Only use accessories and spare parts which have been approved by the man- ufacturer.
Need help?
Do you have a question about the BULL 150 and is the answer not in the manual?
Questions and answers