Table of Contents
Advertisement
preprogrammed code and the time among presses is not bigger than the set
point, then the DoorPhone will pick up and close the corresponding switch (if
set in m=1 or m=5 modes) to the period given by seting in parameters. Then it
will hang up.
2.2.2 DoorPhone with Keyboard
The DoorPhone with keyboard can also include
besides the keyboard up to 16 buttons of direct
dialing always behaving as to be mentioned in
chapter 1.3.3 (page 10) except the code lock. This
one is always situated on keyboard. After keyboard
is connected, the position, where the keyboard is
connected to, should be set in programming
parameter.
The keyboard has two functional buttons – key
symbol = once pressing the numerical combination is considered as the
combination for control of the switches. The second button –X symbol = when
pressing the DoorPhone immediately will hang up.
The number selection on keyboard can be executed in two ways:
-
The incoming person is dialing number as to be done on phone – the
period among button presses should be lower than the value given
by programming parameter. After this period the DoorPhone will lift
up and dial the given number.
-
On buttons the incoming person is dialing a two-digit number (from
01 to 64), which represents the memory number, where the 16-digit
number is stored (same as for buttons). The number dialing is
managed by Day/Night setting or mode for two groups of numbers
(as described in chapter 2.2.1 page 14).
IPDP - installation and operating instructions
15
Advertisement
Table of Contents
