Table of Contents
Advertisement
2 DoorPhone VoIP Operation
2.1 Signaling Overview
The all-purpose guard signals an acoustic conditions they may occur during
operation. Another signaling can be done by means of red LED (placed under
microphone hole). You can listen the signaling samples in Nset setting
program.
Condition
Line lifting up
Line hanging up
Report after calling
Notice about call end
Parameter confirmation
Switch on (Reset)
Error (anything, if unsuitable)
Empty memory (no progr. numb.)
2.2 Visitor at Door
The all-purpose guard function is influenced partly by used guard assembly
(with keyboard or without it) and partly by setting of guard parameters.
2.2.1 DoorPhone without Keyboard
The DoorPhone buttons are provided by nameplates or positions of persons
inside the object. The incoming person will press the corresponding button, the
DoorPhone will lift up the VoIP canale neither immediately (the button is not the
first number from code lock), or with delay and dial the programmed phone
number thru VoIP, but dial number differs by choice mode, which is set in the
DoorPhone :
-
Day/night mode = being the DoorPhone in Day mode, so it is always
dialing a number set in table 1, in Night mode, it is always dialing a
number set in table 2.
-
mode two number group = first press – it always dials a number set
in table 1. By repeated press of the same button or detection of busy
tone after dialing the DoorPhone will select the number from the
second group (table 2). The next press of the same button again
selects a number of the first group, etc........
The switch (code lock) can be controlled by first 10 buttons of DoorPhone. If
the visitor at door presses buttons in such combination that meet the
IPDP - installation and operating instructions
14
Tones
–▄–■–▀–
–▀–■–▄
–▄–■–▀–
–■–■–■–
––█––
–■–▄–■–
–■–■–■–■–■–■–
–█–▄–■–▄–■–▄–
Tone frequency
425-850-1275
1275-850-425
425-850-1275
1275
1275-850-1275
425....
850-1275-1700...
LED
glows
goes
out
glows
glows
glows
blinks
Advertisement
Table of Contents
