Millenium Slow Stick X Assembly Instructions Manual page 7

Step-22: Build two aileron servo blocks from
parts P3 and P5. At this time, go ahead and
complete the other wing half. Be sure to make
the opposite half a mirrored image of the first
half.
Step-23: Install the servo block as shown.
Sand as much of the laser burn from the
wing as possible without distorting the shape of
the wing parts. Sand sheeting and other parts
flush with W1 so when the two wing halves are
brought together, the left and right W1 ribs join
together flush. Be careful not to oversand.
Cover the wing halves with light model
covering before joining them permanently. Do
not completely cover the side of the W1 center
rib.
Step-24: Glue P2 and P4 in place on one wing
half. Use slow drying glue on P2 such as
epoxy. You only need enough glue to attach P2
to the top and bottom spar sticks. Apply glue to
P2 and W1. Now join the two wing halves.
Note the picture shows an uncovered wing. Do
not join the two wing halves until they are
covered. You may also install covered ailerons,
servos and linkage before this step is you so
choose.
Step-25: Cut from 3/16 square sticks: (2) 19-
1/2" (1) 4-1/2", (2) 4", (6) 3-3/4", (2) 3-1/4",
(8) 2-1/2" (2) 2-1/4" and set aside. Be sure to
cut longest to shortest. Use the scraps as much
as possible. Cut (24) aileron stiffeners by using
part A1 or A2 as a cutting guide.
7