Superior VRE3036ZMN Installation And Operation Instructions Manual page 9

INSTALLING FIREPLACE HOOD HS36/HS42
1. Remove protective film from stainless hood.
2. Align three notches located on back side of hood with front face of
fireplace (see Figure 7). Notches should be at least 3
edge of fireplace opening.
3. Hold fireplace hood in place. Using a #10 drill bit, drill through
three notches .
4. Insert three screws through notches in hood into holes in fireplace.
Notches
on Hood
Screws
Figure 7 - Installing Hood
INSTALLING BI-FOLD GLASS DOORS
IMPORTANT: Use only glass doors certified for use
with this fireplace (See Accessories, page 24).
Door Installation
Pivot and spring clips have been installed and pretested at the factory,
but some readjustments may be needed due to movement during
shipping or handling.
Install doors using the following steps. If you find doors do not close
properly or do not appear level or straight, proceed with section on
door adjustment.
1. With bi-fold door completely folded, insert bottom pivot pin into
pivot plate or pivot hole located near bottom corner of front face
opening and swing door to the vertical position making sure top
pins slide into door track. Door is installed when top door pin snaps
into spring clip (see Figure 8).
2. Repeat step 1 for remaining door.
8
INSTALLATION Continued
Fold
Door and
Slide Top
1 / " up from
Pins into
2
Track
Pivot Plate
or Pivot
Hole
WARNING: Fireplace must be operated only with
doors fully opened.
Door Adjustment
Remove doors and slightly loosen lower pivot plate (if equipped) and
upper spring clips. Replace doors and fully close them. Use 1/8" shims
(any material) to level doors. Once the proper setting is achieved,
carefully open doors enough so that you can access pivot and spring
clips with a Phillips screwdriver. Tighten screws (see Figure 9, page 9).
Please read the following care and operation guidelines before operat-
ing your appliance or fireplace.
• Glass doors should be operated in the fully open position only (see
Figure 10, page 9).
• If doors are not fully open, the thermo disk will automatically turn
off burner. See Safety Device on page 15 for instructions on how
to reset the thermo disk.
• When operating doors, do not slam shut or abuse them.
• Always keep area below bottom edge of doors clear from obstacles
or debris.
• Do not operate this appliance if glass doors are broken or damaged.
• Do not use abrasive liquids or cleaners for cleaning of glass and
door trims. Any household glass cleaner should suffice. Do not
clean doors when hot, allow the appliance to cool before cleaning.
Superiorfireplaces.US.com
Figure 8: Installing Bi-Fold Glass Door
Spring Clip
Insert Pin
into Spring
Clip
Insert Bottom
Pivot Pin into
Pivot Plate
or Hole and
Swing Door
into a Vertical
Position
127042-01_B