Getting Set Up - BT Video Baby Monitor 630 User Manual

Getting set up

Take the battery cover off the Parent unit by sliding and lifting it. Check the battery
1
wire is connected to the socket inside the monitor. Put the battery cover back on by
sliding it towards the middle of the unit until it clicks into place.
To charge the Parent unit, plug the
2
cable into the Parent unit, then plug
it into the mains power socket and
switch the socket on.
Leave to charge for 12 hours.
4
Need some help? Call 0800 218 2182* or go to bt.com/producthelp
Tip
To replace the battery, pull
it out of the compartment
and unplug the battery
connector from the socket.
Then follow the instructions
in step 1 to install it.
Tip
The first time you use the
Parent unit, or if you haven't
used it for a long time, it'll
take 12 hours to fully charge.
When the battery gets very
low, it'll take about 30
minutes to charge enough
for you to use it for a short
time.
To charge the Parent unit in
the shortest amount of time,
turn it off while it's charging.