Table of Contents
Advertisement
MAINTENANCE
LIGHTING PILOTS
HI-SIM-WARM V ALVE
30 inch range:Slide the two catches,
Besureall surface andovencontrols are
ADJUSTMENT
located at each rear corner of the
setin theOFFposition priorto supplying
(if equipped)
oven bottom,toward the front of the
gasto the appliance.
The WARM setting should producea
oven. Lift the rear edge of the oven
bottom slightly, then slide it back
When the range is first installed,the
stable flame when turning the knob
from HI to WARM. On conventional
until the holesin the front edge of the
pilots may be difficult to light due to
oven bottomclear the pins in the oven
air in the gas line. To bleed off air
surface burners, the flame should be
front frame. Remove oven bottom
from the line, hold a lighted match
1/8 inch or lower and must be stable
from oven.
next to the burner and turn knob on.
on all ports on WARM setting. For
When the burner lights, turn the knob
sealed burners, the flame should
To replace: F it holes onto pins, lower
off and proceed as directed below,
extend to the outer edge of the lip on
rear of oven bottom and slide the
the burner cap on the WARM setting.
catchesback to lock oven bottominto
SurfaceBurnerand Griddle/5thBurner
place.
Pilots:Remove or raise and support
To adjust:Operate burner on HI for
cooktop on metal rod. Hold lighted
about 5 minutes to preheat burner
match near the pilot ports,
cap. Turn knob back to WARM;
t_
remove knob, and insert a small
Oven Pilot: Remove oven racks and
screwdriver into the center of the
oven
bottom.
With
the
oven
valve stem. Adjust flame size by
thermostat knob in the OFF position,
turning adjustment screw in either
_
2
hold a lighted match to the pilot
direction. Flame must be of sufficient
located at the back end of the oven
size to be stable on all burner ports.
burner. Once pilot is lit, replace oven
NEVERadjust flame size at the HI or
_/__,l
_
bottom and racks.
SIMMER settings. If flame adjustment
3 . ._
is needed,adjust ONLYon the WARM
_.._,_. jF_,
setting.
38 inch range: Push oven bottom
_'_
toward back of oven. Lift front end
'
'/
up. Pull toward front of oven and
remove.
To replace:Reverseprocedure.
OVEN PILOT
SURFACE BURNER
PILOTLESS IGNITION
20, 30 and36 inch rangesequipped with
gig bar-typepilotlessignition: O ven can
not be manually lighted with a match
during a power failure.
The oven on the 20 inch range will
have one of the ignition systems
described below:
1. Spark-type ignition.
Be sure oven thermostat knob is
OFF. Open broiler drawer and
HINT:
removebroiler insert and pan. Hold
Protect
oven
bottom
against
a lighted match next to pilot as
excessive spillovers (especially acid
illustrated above. Replace broiler
or sugary spills). Use the correct size
insert and pan.
cooking utensil. Placing a sheet of
2. Gig bar-typeIgnition.
aluminum foil, that is slightly larger
With this type of ignition system,
than the cooking utensil on the rack
the oven will not operate during a
below the utensil will catch spills,
power failure or if the range is dis-
connected from the wall outlet.
14
Advertisement
Table of Contents
